Abstract:
To address wellbore instability problems, such as borehole collapse and pipe sticking, that frequently occur while drilling through the upper mudstone intervals of the Shaximiao and Ziliujing Formations in the Dazu well area of the western Chongqing block. X-ray diffraction, scanning electron microscopy, and compressional- and shear-wave velocity measurements were conducted to characterize the mineral composition, microstructure, and acoustic properties of the mudstone. Hydration swelling and uniaxial compressive strength tests were subsequently performed on mudstone samples immersed in fresh water, field drilling fluid, and KCl solutions of different concentrations. The effects of hydration on the mechanical strength, brittleness, and time-dependent behavior of the mudstone were investigated. On this basis, wellbore stability under different degrees of hydration-induced damage was evaluated to determine the influence of hydration damage on the critical collapse pressure. The results show that the target mudstone is dense, hard, and brittle, and that its hydration process exhibits two distinct stages characterized by rapid hydration in the initial stage and a gradual stabilization thereafter. With increasing immersion time, both the uniaxial compressive strength and elastic modulus decrease nonlinearly, while the failure mode gradually changes from brittle tensile splitting to plastic shear failure. Hydration of clay minerals and the resulting pronounced strength degradation are identified as the primary causes of wellbore instability. Model calculations indicate that the equivalent density of the critical collapse pressure increases nonlinearly with increasing hydration damage. Based on the experimental and modeling results, it is recommended that the field drilling-fluid density be maintained at approximately 1.15 g/cm
3, accompanied by an appropriate increase in the concentration of inhibitory ions such as K
+ to enhance hydration inhibition and ensure the long-term stability of the second drilling interval. These findings provide a theoretical basis for wellbore stability evaluation, drilling-parameter design, and drilling-fluid formulation optimization in western Chongqing and other areas with similar geological conditions.