A Method for Improving Underbalanced Pressure Design in Injection Wells Using Negative Pressure Blocking
-
摘要: 为了改善注水井负压解堵的效果,对注水井负压解堵的负压值设计方法进行了研究.根据注水井的渗流特点,利用注水产生的表皮附加压降来修正最小负压值;以防止储层出砂为原则设计最大负压值;再根据Conocophillips公司的负压值设计方法确定最佳负压值;最后,从防止套管挤毁和保证储层稳定2方面对负压值进行校核.采用新的负压值设计方法对车2井、车89井进行了解堵负压值设计,2口井应用新方法推荐的负压值进行解堵之后,注水压力均明显降低,且短时间内注水压力没有出现大幅度升高.研究结果表明,在中高渗透砂岩油层的垂直注水井中运用新方法计算的负压值解堵后,既清除了近井地带的污染,又保证了孔眼和储层的稳定性.Abstract: In order to improve the effect of negative pressure blocking in injection wells,the design method of negative pressure blocking in injection wells was studied.According to the seepage characteristics of injection wells,an additional pressure drop due to the skin factor was utilized to correct the minimum negative pressure.The maximum negative pressure was designed following principles of sand control.Afterwards,the optimized negative pressure was determined according to the negative pressure design method of ConocoPhillips.Finally,the negative pressure was checked on the basis of preventing casing damage and ensuring the stability of pay zone.The new method of the negative pressure value design was applied to Well Che2 and Well Che89.After the utilization of the negative values recommended by the new method,both water injection pressures of Well Che 2 and Well Che 89 were lowered obviously,and the water injection pressures did not increase substantially.The results showed that using the new negative pressure plugging method in vertical wells of medium or high permeability sand stone pay zones could clear the pollution of the near well bore area and ensure the stability of bores and pay zones.
-
Keywords:
- injection wells /
- negative pressure blocking /
- negative pressure value /
- skin factor
-
-
[1] 王羽曦.超短半径水平井钻井技术在注入井解堵中的应用[J].石油钻探技术,2013,41(5):89-92. Wang Yuxi.Application of ultra-short radius horizontal well drilling technology in plugging removal in injectors[J].Petroleum Drilling Techniques,2013,41(5):89-92. [2] 曲占庆,何利敏,战永平,等.商三区注入水储层伤害判断及解堵实验[J].断块油气田,2014,21(2):232-235. Qu Zhanqing,He Limin,Zhan Yongping,et al.Damage judgment of injected water reservoir and unplugging experiment in Shangsan Region[J].Fault-Block Oil and Gas Field,2014,21(2):232-235. [3] 朱继东,张建国,石爱霞,等.声波解堵综合配套技术研究[J].石油钻探技术,2006,34(1):59-61. Zhu Jidong,Zhang Jianguo,Shi Aixia, et al.Comprehensive supporting technology for plug removal with sonic wave[J].Petroleum Drilling Techniques,2006,34(1):59-61. [4] 苏月琦,汪召华,赵磊,等.低渗砂岩气田井周解堵技术研究及应用[J].断块油气田,2011,18(4):524-526. Su Yueqi,Wang Zhaohua,Zhao Lei, et al.Research and application of plug removal technique near wellbore area in low permeability sandstone gas field[J].Fault-Block Oil and Gas Field, 2011,18(4):524-526. [5] 许彬,熊友明,张自印,等.负压射孔参数优化设计[J].重庆科技学院学报:自然科学版,2010,12(3):67-69. Xu Bin,Xiong Youming,Zhang Ziyin,et al.Design on parameters optimization of under-balance pressure perforating[J].Journal of Chongqing University of Science and Technology:Natural Science Edition,2010,12(3):67-69. [6] 汪伟英.注水井解堵增注技术综述[J].钻采工艺,1995,18(4):35-37,46. Wang Weiying.Review of well plugging increase injection technology of the water injection[J].Drilling Production Technology,1995,18(4):35-37,46. [7] 卢瑜林.注水井水力解堵技术的研究与应用[J].江汉石油科技,2006,16(1):40-42. Lu Yulin.Research and application of water injection well plugging technology of hydraulic[J].Jianghan Petroleum Science and Technology,2006,16(1):40-42. [8] 李玉光,邢希金,李莹莹,等.针对渤海A油田注水井堵塞的解堵增注液研究[J].石油天然气学报,2013,35(11):132-135,144. Li Yuguang,Xing Xijin,Li Yingying,et al.According to the block and increase research liquid injection solution for water injection wells in Bohai A Oilfield jam[J].Journal of Oil and Gas Technology,2013,35(11):132-135,144. [9] 郭旭光,李生莉,周蔚云.负压法储层解堵增注工艺[J].石油钻采工艺,1994,16(2):86-90. Guo Xuguang,Li Shengli,Zhou Weiyun.Negative pressure method for reservoir plugging removal technology[J].Oil Drilling Production Technology,1994,16(2):86-90. [10] 李拥军,黄继红,刘健,等.一种新的射孔负压设计方法[J].石油钻采工艺,2010,32(2):118-121. Li Yongjun,Huang Jihong,Liu Jian,et al.Research and application of a new method of under-balanced perforating pressure design[J].Oil Drilling Production Technology,2010,32(2):118-121. [11] 万仁溥.现代完井工程[M].3版.北京:石油工业出版社,2008:32-40. Wan Renpu.Advanced well completion engineering[M].3rd ed.Beijing:Petroleum Industry Press,2008:32-40. [12] Bell W T.Perforating underbalanced evolving techniques:includes associated papers 13966 and 14140[J].Journal of Petroleum Technology,1984,36(10):1653-1662.
[13] Jan B M,Rae G R,Noor M I,et al.Increasing production by maximizing underbalance during perforation using nontraditional lightweight completion fluid[J].SPE Drilling Completion,2009,24(2):226-331.
[14] Crawford H R.Underbalance perforating design[R].SPE 19749,1989.
[15] King G E,Anderson A,Bingham M.A field study of underbalance pressures necessary to obtain clean perforations using tubing-conveyed perforating[R].SPE 14321,1986.
[16] Handren P J,Jupp T B,Dees J M.Under balance perforating and stimulation methods for wells[R].SPE 26515,1993.
[17] Behrmann L A.Underbalance criteria for minimum perforation damage[J].SPE Drilling Completion,1996,11(3):173-177.
[18] Tariq S M.New,generalized criteria for determining the level of underbalance for obtaining clean perforations[R].SPE 20636,1990.
[19] 朱发银,郑国芹.油气井表皮系数及其确定[J].胜利油田职工大学学报,2001,15(2):1-3. Zhu Fayin,Zheng Guoqin.Oil and gas well skin factor and its determination[J].Journal of Shengli Oilfield Staff University,2001,15(2):1-3. -
期刊类型引用(10)
1. 温晓松，柳贡慧，李军，郭雪利. 恒扭矩工具组合式非标碟簧试验与数值分析. 科学技术与工程. 2021(25): 10670-10679 . 
百度学术
2. 田峥，秦世利，游尧，陈斌，田波. 古潜山巨厚花岗岩地层综合提速与配套工艺技术研究. 中国石油和化工标准与质量. 2021(16): 156-158+160 . 百度学术
3. 温晓松，柳贡慧，王烊，李军，李汉兴. 石油钻井中非标碟簧优选设计及力学性能研究. 石油机械. 2020(06): 9-17 . 百度学术
4. 刘为民. 深井钻井井下抗制动工具数值仿真与试验. 长江大学学报(自然科学版). 2020(06): 62-67 . 百度学术
5. 曹继飞，田京燕，张辉. 弱胶结砂砾岩地层钻头研制及提速工具配套研究. 探矿工程(岩土钻掘工程). 2019(04): 88-91 . 百度学术
6. 查春青，柳贡慧，李军，席岩，汪伟. PDC钻头扭转振动减振工具设计及现场应用. 特种油气藏. 2019(02): 170-174 . 百度学术
7. 兰凯，刘香峰. 钻柱恶性振动识别与抑制技术研究进展. 吉林大学学报(地球科学版). 2017(01): 203-214 . 百度学术
8. 吴小雄，朱浩铭，王德贵，余朋伟，邹子由，郗秦阳. 钻井转矩保护器的研制. 机械工程师. 2017(11): 100-101+104 . 百度学术
9. 梁奇敏，何俊才，张弘，张翼，刘新云. 钻井提速工具经济性预测评价方法. 石油钻探技术. 2017(03): 57-61 . 本站查看
10. 张辉. PDC钻头恒扭矩工具在XING101井的应用. 石油机械. 2015(12): 15-18+24 . 百度学术
其他类型引用(1)
计量
- 文章访问数: 2877
- HTML全文浏览量: 55
- PDF下载量: 3518
- 被引次数: 11
下载:
